Laserfiche WebLink
Site ID: 782350 <br /> January 26, 2015 <br /> Page 2 <br /> Introduction <br /> The purpose of this report is to summarize results of the structural analysis performed on the 100 ft <br /> Valmont Monopole with a proposed 10 ft extension located at Badger Road, Madison, WI, Dane <br /> County (site #782350). The tower was originally designed and manufactured by Valmont (Drawing <br /> #19198-99, dated September 17, 1999). Refer to the attached drawings for the proposed extension <br /> design. <br /> Analysis <br /> The tower was analyzed using Semaan Engineering Solutions, Inc., Software. The analysis <br /> assumes that the tower is in good, undamaged, and non-corroded condition. The analysis was <br /> performed in conformance with ANSI/TIA-222 Rev G and local building codes for a basic wind <br /> speed of 90 mph no ice and 40 mph with 3/4" radial ice (3-second gust), Structure Classification <br /> II, Exposure C. This is in conformance with the IBC 2009: Section 1609.1.1, Exception (5) and <br /> Section 3108. <br /> Basic Wind Speed: 90.0 mph <br /> Radial Ice: 40 mph w/0.75" ice <br /> Code: ANSU IA-222 Rev G <br /> Antenna Loads <br /> The following antenna loads were used in the tower analysis. <br /> Existing Antennas <br /> EJev.(i) Qty Antennas Mount Coax(in) Carrier <br /> 3 SMM-2CR0480800 RRH <br /> 3 ET-X-TS-70-16-62-18-iR-RD (3) 1.12 <br /> 89.1 3 SMM-2LD0581900 RRH Low Profile Platform Black Sprint <br /> 3 RRHv3 Fiber <br /> 3 ET-X-WM-18-65-8P <br /> 75.0 3 HB-X-AW-19-65-0TM-RET (6)7/8 US Cellular <br /> 75.0 3 AIR 21 B4A/B12 B5P Platform w/Rail (3)Hybrid US Cellular <br /> Lines <br /> 56.0 3 BXA-80063/6CF (6)7/8 (Future) <br /> 3 AM-X-CW-18-65-00T-RET Platform w/Rail <br /> 56.0 3 RIUs (6) 1 5/8 US Cellular <br /> Proposed Antennas <br /> Elev.(i) Qty Antennas Mount Coax(in) Carrier <br /> 3 RRUS A2 Modules <br /> 107.0 3 RRUS12 Standoff Mounts HFT1206- <br /> 1 RCMDC-3315-PF-48 Verizon <br /> 24S26 1" <br /> 104.0 6 CWWX063X25G00 Platform w/Rail (12) 1 5/8 <br /> 6 BWC-TMA-700C-VG <br /> All transmission lines are assumed running inside of pole shaft. <br /> All new access holes shall be reinforced with welded rims that are compatible with the pole and <br /> to be sized and supplied by pole manufacturer. <br /> Semaan Engineering Solutions Holdings,LLC <br /> 1079 N.205th Street,Elkhom,NE 68022 <br /> Phone:402-289-1888 <br />