Laserfiche WebLink
Page 2 of 3 <br /> To: 'dacirco verizon.net' <br /> Subject: RE: zoning inspection, 4887 Kramer Court, Sun Pr 34 <br /> Thank you for your e-mail. <br /> Section 10.01(8) of the Dane County Code of Ordinances (DCCO) states that building height is <br /> defined as the vertical distance, measured from the mean elevation of the finished grade along <br /> the front of the building to the highest point on the roof for flat roofs; to the mean height level <br /> between the eaves and the ridge for gable and hip roofs; to the deck line for mansard roofs. <br /> Section 10.123(4)(b) of the DCCO states that the maximum height for residential accessory <br /> buildings in the A- 1 Exclusive Agriculture District is 16 feet. <br /> A new elevation drawing needs to be submitted and reviewed prior to construction. <br /> The Dane County Zoning Administrator, Mr. Roger W. Lane, III, 608-266-9078, <br /> lane.rogerco.dane.wi.us, will need to review and approve the mean elevation of the finished <br /> grade along the front of the building. The fax number for the Dane County Zoning Division is <br /> 608-267-1540. <br /> From the mean elevation of the finished grade along the front of the building to the peak of the <br /> roof is the first number in the calculation of the building height. <br /> From the mean elevation of the finished grade along the front of the building to the bottom of the <br /> eave is the second number in the building height calculation. <br /> Mr. Lane will need to review and approve the second number in the calculation since the eave <br /> height is going to be different on each side of the garage. <br /> Mr. Lane will be returning from vacation on Thursday, December 4, 2008. <br /> Russell L. Bartlett, 608-267-3960, Zoning Inspector, County of Dane, 608-267-3960. <br /> Original Message <br /> From: dacirco @verizon.net [mailto:dacirco @verizon.net] <br /> Sent: Wednesday, November 26, 2008 11:31 AM <br /> To: Bartlett, Russell <br /> Subject: RE: zoning inspection, 4887 Kramer Court, Sun Pr 34 <br /> Russell, <br /> After speaking with you on Monday 11/24, you mentioned my zoning is A-1 <br /> EX (Access Dane confirms) and my accessory building height can be 16 ft. I <br /> was told when submitting for my permit that I could only be at 12 ft. <br /> maximum. I would like to maximize the wall height and go to 12 ft walls with <br /> a truss bearing to peak height at 6.33 ft, therefore (12 ft wall + (12 ft wall + <br /> 6.33 ft truss))/2 would be 15.165 ft which would meet the 16 ft maximum. <br /> May I do this? Do you need any other drawings, etc to do this? <br /> Will you do the 2nd inspection? <br /> Thank you for your assistance. <br /> Dean Circo <br /> On Wed, Nov 12, 2008 at 7:06 AM, Bartlett, Russell wrote: <br /> > Thank you for your call. <br /> The first inspection was to verify the setback requirements for your new <br /> garage. The minimum required setback of 30 feet from the front property line, <br /> the minimum required setback of 10 feet from the side lot line, and the <br /> minimum required setback of 50 feet to the rear lot line. <br /> Please call to schedule your second inspection when the roof trusses are <br /> installed so that I may verify the height of the garage. The permit application <br /> shows the proposed average height of the garage is 11.914 feet. <br /> Again, thank you for your cooperation. <br /> 06/01/09 <br />