DCPZP-2015-00952 - Laserfiche WebLink

Home Browse Search

NICKOLAS C GEORGE SR Page 2 8/24/2015 • SPS 361.31(2)(e)/I3C 1608&SPS 362.1603(6)-Submitted revised unbalanced snow calculations indicated • incorrect unbalanced snow loadings on revised plans snow load diagrams 1/7 for hd is still incorrect for add roof. • IBC 1008.1.2-All egress doors shall be pivoted or side hinged unless a listed exception can be met. Doors shall swing in the direction of egress travel where serving an occupant load of 50. Sliding gate outside of main entrance double doors is not permitted at that location,unless it meets IBC 1008.1.4.3 provisions,as well as panic hardware provisions for egress doors serving rooms or spaces with an occupant load of 50 or more in a Group A-2 occupancy shall not be provided with a latch or lock unless it is panic hardware or fire exit hardware. [Note that IBC 1008.1.4.5 provision for security gates applies to only Groups B,F,M&S occupancies.] Submit—Please submit the following additional components or systems to our agency prior to installation or occupancy of the building. Be aware that additional fees are required if submittals are not timely. Our agency offers a number of worksheets and checklists for the Commercial Building Code at: http://dsps.wi.goy/Documents/Industry%20Services/Forms/Commercial%20B uildings/Combined %20Worksheets%20Instructions%20 2009%20ICC .pdf that may assist you in preparing your submittal. Record approval information for each required submittal below. When ready for building occupancy,provide this information to your municipal building official,along with any required compliance statement,in order to obtain any municipal occupancy permit or license. • SPS 361.30(3)-This approval does not include heating,ventilating or air conditioning. The owner should be reminded that HVAC plans, calculations, and appropriate fees are required to be submitted for review and approval prior to installation. Building Designer should coordinate with HVAC design to avoid problems with clearance to combustibles,dampers etc.The submitted HVAC plans shall match the approved building plans. Building Designer is requested to provide a complete set of plans,Energy Calculations and the Building plan review Transaction I.D.number to the HVAC Designer to help coordinate review. Note as per SPS 302.10 installation of HVAC without approved plans could result in double plan review fees. • SPS 361.30(3)-Submit,prior to installation,one(1)set of properly signed and sealed wood roof truss plans, complete member&plate sizing calculations, a completed SB-118 application form including this transaction number and signed by the building designer to Industry Services,P.O.Box 7162,Madison WI 53707-7162. Note as per SPS 302.31(1)(d)4.the fee for a structural component submitted after project completion shall be an additional$250. Reminders • SPS 361.36(1)(a)&(b)-The building shell shall be closed within two years of the initial approval date of this project. Also,this approval will expire three years after the date of initial approval of this project if the work covered by this approval is not completed and the building ready for occupancy within those three years. • IBC 1008.1.9.3-Egress doors shall be readily openable from the egress side of the door without the use of keys or special knowledge or effort. Verify this to building inspector for hardware at main entrance(if gate is used). A full size copy of the approved plans,specifications and this letter shall be on-site during construction and open to inspection by authorized representatives of the Department,which may include local inspectors.If plan index sheets were submitted in lieu of additional full plan sets, a copy of this approval letter and index sheet shall be attached to plans that correspond with the copy on file with the Department. If these plans were submitted in an electronic form, the designer is responsible to download,print,and bind the full size set of plans along with our approval letter. A department electronic stamp and signature shall be on the plans which are used at the job site for construction. - All permits required by the state or the local municipality shall be obtained prior to commencement of construction/installation/operation. You are responsible for complying with state and federal laws concerning construction near or on wetlands,lakes,and streams. For more information, visit the Department of Natural Resources wetlands identification web page or contact a Department of Natural Resources service center.Nothing in this approval limits the power of municipalities to make or enforce additional or more stringent regulations, providing the regulations do not conflict with this code or any other rule of the department or any law.This plan has not been generally reviewed for compliance with fire code requirements,including those for fire lanes and fire protection water supply,so contact the local fire department for further information.