DCPZP-2015-00952 - Laserfiche WebLink

Home Browse Search

STEVEN TESMER Page 2 11/13/2015 • Comm 83.52 Responsibilities. The owner of a POWTS shall be responsible for ensuring that the operation and maintenance of the POWTS occurs in accordance with this chapter and the approved management plan under s. Comm 83.54(1). • Comm 83,52(2) A POWTS that is not maintained in accordance with the approved management plan or as required under s.Comm 83.54(4)shall be considered a human health hazard. • Comm 83.52(3) The activities relating to evaluation and monitoring mechanical POWTS components after the initial installation of the POWTS in accordance with an approved management plan shall be conducted by a person who holds a registration issued by the department as a registered POWTS maintainer, • The current owner,and each subsequent owner,shall receive a copy of this letter including instructions relating to proper use and maintenance of the system, Owners shall receive a copy of the appropriate operation and maintenance manual and/or owner's manual for the POWTS described in this approval. • The owner is responsible for submitting a maintenance verification report acceptable to the county for maintenance tracking purposes. Reports shall be submitted at intervals appropriate for the component(s)utilized in the POWTS. • A component specified in this POWTS design requires servicing at an interval of 12 months or less. Pursuant to s.Comm 83.21(2)(c)5,Wis.Adm.Code,if any part of a POWTS requires servicing or maintenance at an interval of 12 months or less,a notice of the need for such servicing or maintenance must be recorded with the deed for the property. If the maintenance or service notice has not been recorded,a sanitary permit can not be issued by the sanitary permit issuing agent. • This approval does not include plans for the general plumbing systems or sewer piping leading to the septic/holding tank that may be required for this project. See section SPS 382.20,Wis.Adm.Code,to determine if plan submittal and approval is required, • Supply duplex pumps with duplex controls. Reminder • The orientation of the mound system must be such that the longest dimension is oriented along the surface contour per SPS 383,44(6)(a)2. • Limit activities in the area 15'beyond the down slope edge of the mound per Mound Component Manual. • Surface water drainage shall be diverted away from the system area per Mound Component Manual. • Materials shall conform to the requirements of SPS 384.10.No fixture,appliance,appurtenance,material, device or product may be sold for use in a plumbing system or may be installed in a plumbing system,unless it is of a type conforming to the standards or specifications of chs,SPS 382 and 383 and this chapter and ch. 145, Stats. • The existing POWTS must be properly abandoned per s.SPS 383.33 Wis,Adm.Code, A copy of the approved plans,specifications and this letter shall be on-site during construction and open to inspection by authorized representatives of the Department,which may include local inspectors. All permits required by the state or the local municipality shall be obtained prior to commencement of construction/installation/operation. In granting this approval the Division of Industry Services reserves the right to require changes or additions should conditions arise making them necessary for code compliance.As per state stats 101.12(2),nothing in this review shall relieve the designer of the responsibility for designing a safe building,structure,or component. Inquiries concerning this correspondence may be made to me at the telephone number listed below,or at the address on this letterhead.